Eliminating Wear on Chains and Chain Guides

The Problem

UHMW is frequently used as a bearing surface underneath drive chains on conveyor systems.The material is typically mechanically fastened in place by countersunk fasteners using 1/4″ thick material as a minimum thickness. Leaving at a minimum a 1/16″ working thickness.

The Solution

By using an adhesive backed product, the material thickness can be .062″ and easily installed in a matter of minutes and at a considerable cost savings as compared to 1/4″ thick material. If the chain guide is over 10 feet long, our continuous length rolls can eliminate potential “-catch” points or seams to provide a much smoother operation of the system.

This page is also available in: Spanish